...
| Iframe | ||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Often, doors will have a Request request-to Exit -exit button or sensor that will unlock the door from the inside.
Port — select the port for the Request request-to Exit -exit device to which the entry is wired.
Mode — this is an electrical term regarding how the Request request-to Exit -exit device sends the command to the ACU. Your installer will be able to give you guidance on whether the Mode should be set to Normally Closed or Normally Open for a particular entry configuration.
Trigger Relay to Unlock Entry — if enabled, a triggered REX will open the associated relay(s) and prevent forced-open alarms.
...
Port — select the port for the Wiegand device to which this entry is wired.
Mode — select the mode to set which direction the card credential data is sent:
Use Input to receive data from devices such as a Wiegand reader.
Use Output (Gateway) to send credential data to a third—party third party control panel. Refer to the installation guide for more information.
...
Suppose an entry has more than one of any controls (Avigilon readers, Entry/Exit hardware, contact sensor, request-to-exit, or Wiegand device) installed. In that case, you can select which additional control(s) you would like to associate with the entry.
Once you add control, it will appear in the relevant section on this page.
...