Page Comparison

...

To set up Wave to Unlock:

...

1. Go to https://control.openpath.com/login and log in

2. To check if your Openpath readers are compatible, go to Dashboards > Hardware Dashboard, click on an ACU to expand it, then check that the HW Ver is 22 and the SW version is 2.5.5 or higher

3. Image Added

   To enable Wave to Unlock on an Entry, go to Sites > Entry Management and click on the Entry

4. Under Openpath Reader settings, enable Touch/Wave to Unlock

   Image Added

5. The Mobile Authorization Range determines how close the mobile device must be to the Openpath reader in order to authorize the unlock

6. The Touch/Wave Detection Range specifies how close the hand must be to the Openpath reader to initiate the unlock attempt—this behavior may vary depending on your environment and this setting might require adjustment

7. At the bottom of the page, click Save