Inputs
The Openpath Avigilon 16 I/O Elevator board has 16 general-purpose inputs. The general-purpose inputs respond to voltages between 3V and 24V. The inputs will not respond directly to a switch or relay connected to the ground. To use these inputs with a switch or relay, connect one side of the switch to the input and the other side of the switch to a supply voltage between 3V and 24V. If desired, you can add a 1k ohm resistor in series with the switch.
...
| Iframe | ||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Outputs
The Openpath Avigilon 16 I/O Elevator board has 16 relay outputs, which are typically used for elevator buttons. Interrupt one of the signal wires from each button and run through the C and NC contacts for the corresponding relay on the 16 I/O Elevator Board. See the example below.
...