...
| Markdown |
|---|
| LED | Step | | ----| -----| |  | (1) If powering using PoE, plug in Ethernet; if powering with an external power supply, plug in Ethernet and connect power to POWER IN. The Status LED will be **solid cyan**. | |  | (2) In the Open Admin app, locate the org to which you're provisioning hardware, either on the list or using search, then tap on the org name. | |  | (3) Wait until the Status LED is **solid blue**, then press the Admin button (see above) on the SDC. **Note:** SDC will disconnect from the Open Admin app after 5 minutes of inactivity; press the Admin button again to reset the timer. |  | (4) When the Status LED is **blinking purple**, in the app, tap on the last four digits of the serial number for the SDC. | |  | (5) When the Status LED changes to **solid purple**, tap **Test Internet Connection** and wait for a green **YES** to appear before proceeding with the next step. **Note:** This checks if the ACU/SDC can ping [https://api.openpath.com/health](https://api.openpath.com/health) If this step fails, refer to [Troubleshooting the SDC](https://supportopenpath.openpath.com/how-do-i-set-up-the-single-door-controller-H1p1rosId#troubleshootatlassian.net/servicedesk/customer/portal/16/article/760217849?src=-1563331011#troubleshoot). | |  | (6) If the Internet connection test is successful, tap **Provision Device** in the app. | |  | (7) Tap on the ACU Name that you want to provision to (this is the name of the SDC you created in the Control Center), then tap **Yes** to proceed. | |  | (8) The Status LED will **blink yellow**; the app will send notifications when the SDC provision state changes from **Unprovisioned** to **Provisioning in progress** to **Provisioning complete**. | |  | (9) When setup is complete, the Status LED will change to **solid white**. | |
...