...
| Markdown |
|---|
 |
Setting up the SDC
| Markdown |
|---|
|------|---------
|  | (1) If powering using PoE, plug in Ethernet; if powering with an external power supply, plug in Ethernet and connect power to POWER IN. The Status LED will be **solid cyan**
|  | (2) In the Open Admin app, locate the org to which you’re provisioning hardware, either on the list or using search, then tap on the org name
|  | (3) Wait until the Status LED is **solid blue**, then press the Admin button (see above) on the SDC. **Note:** SDC will disconnect from the Open Admin app after 5 minutes of inactivity; press the Admin button again to reset the timer
|  | (4) When the Status LED is **blinking purple**, in the app, tap on the last four digits of the serial number for the SDC
|  | (5) When the Status LED changes to **solid purple**, tap **Test Internet Connection** and wait for a green **YES** to appear before proceeding with the next step. **Note:** This checks if the ACU/SDC can ping  If this step fails, refer to 
|  | (6) If the Internet connection test is successful, tap **Provision Device**in the app
|  | (7) Tap on the ACU Name that you want to provision to (this is the name of the SDC you created in the Control Center), then tap **Yes** to proceed
|  | (8) The Status LED will**blink yellow**; the app will send notifications when the SDC provision state changes from **Unprovisioned** to **Provisioning in progress** to **Provisioning complete**
|  | (9) When setup is complete, the Status LED will change to **solid white** |
Solid cyan | (1) If powering using PoE, plug in Ethernet; if powering with an external power supply, plug in Ethernet and connect power to POWER IN The Status LED will be solid cyan |
Solid cyan | (2) In the Open Admin app, locate the org to which you’re provisioning hardware, either on the list or using search, then tap on the org name |
Solid blue | (3) Wait until the Status LED is solid blue, then press the Admin button (see above) on the SDC Note: SDC will disconnect from the Open Admin app after 5 minutes of inactivity; press the Admin button again to reset the timer |
Blinking purple | (4) When the Status LED is blinking purple, in the app, tap on the last four digits of the serial number for the SDC |
Solid purple | (5) When the Status LED changes to solid purple, tap Test Internet Connection and wait for a green YES to appear before proceeding with the next step Note: This checks if the ACU/SDC can ping https://api.openpath.com/health If this step fails, refer to Troubleshooting the SDC |
Solid purple | (6) If the Internet connection test is successful, tap Provision Device in the app |
Solid purple | (7) Tap on the ACU Name that you want to provision to (this is the name of the SDC you created in the Control Center), then tap Yes to proceed |
Solid yellow | (8) The Status LED will blink yellow; the app will send notifications when the SDC provision state changes from Unprovisioned to Provisioning in progress to Provisioning complete |
Solid white | (9) When setup is complete, the Status LED will change to solid white |
...